Kickstand Photo Panel
5" x 7" White Textured Hardboard Kickstand Photo Panel
A Template for this item can be found at:
HARDBOARD PHOTO PANELS SUBLIMATION
- sublimatable substrate
- sublimation transfer
- teflon or scratch paper
- heat tape (H107)
- soft paper towel (optional)
Heat press settings:
- temperature - 400 degrees F
- dwell time - 1:00 - 1:30 minutes
- pressure - light to medium
Note: The recommended settings above for sublimation may need adjustments for
best results. Sublimation settings will vary depending on the heat press brand
and model ink and paper and atmospheric conditions.
2nd Note: The layers of soft paper towel help to trap ink that is dispersed
outside of the edges of the substrate if there is an overprint area or full
bleed in the artwork.
Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel (optional)
5. teflon sheet or scratch paper
1. Remove the protective plastic coating if any from the substrate.
2. Position the substrate onto the transfer and adhere transfer to substrate
using heat tape.
3. Place the transfer and substrate into the press (transfer on top of
4. Place the teflon sheet or scratch paper over the transfer.
7. Press the items using the sublimation settings listed above.
8. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
9. Remove transfer from substrate.
- If the image of the final product appears light increase the pressure or
the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed reduce the dwell time slightly (5-15 seconds).
Buy 5 - 100 and get 15% off