Photo Frame 4x6 opening
A template for this item can be found at:
SUBLI-TRU FRAME SUBLIMATION
Note: The recommended settings above for sublimation may need adjustments for
best results. Sublimation settings will vary depending on the heat press brand
and model ink and paper and atmospheric conditions.
- sublimatable substrate
- sublimation transfer
- teflon or scratch paper
- heat tape (H107)
- soft paper towel (optional)
Heat press settings:
- temperature - 390 degrees F
- dwell time - 1:10 - 1:25 minutes
- pressure - light to medium
Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel (optional)
5. teflon sheet or scratch paper
1. Remove the back easel and the glass
2. Position the substrate onto the transfer and adhere transfer to substrate
using heat tape. Do not tape too tight as it can pull off the fabric on the
3. Place the transfer and substrate into the press (transfer on top of
4. Place the teflon sheet or scratch paper over the transfer.
5. Press the items using the sublimation settings listed above.
6. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
7. Remove transfer from substrate.
- If the image of the final product appears light increase the pressure or
the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed reduce the dwell time slightly (5-15 seconds).
Buy 5 - 1000 and get 15% off